ADTRAN AOS Version R10.1.0 Command Reference Manual page 3108

Command Reference Guide Ethernet OAM CFM Command Set
snmp-trap fault alarm
Use the snmp-trap fault alarm command to configure and send Simple Network Management Protocol
(SNMP) traps for fault alarms generated from a maintenance endpoint (MEP). Use the no form of this
command to disable SNMP fault alarm notification.
Syntax Description
No subcommands.
Default Values
By default, SNMP fault alarm notification is disabled.
Command History
Release 17.4 Command was introduced.
Functional Notes
SNMP notification is an alternate method to configuring and receiving Ethernet operations, administration,
and maintenance (OAM) connectivity fault management (CFM) alarm notifications through the AOS event
priority system. SNMP notifications of alarms are sent to the fault alarm address configured on the MEP
reporting the fault. No SNMP notification is sent when an alarm clears.
For more information regarding Ethernet OAM CFM, refer to the Ethernet OAM CFM in AOS configuration
guide available online at https://supportforums.adtran.com (article number 3013).
Usage Examples
The following example enables SNMP notification for alarm notifications from this MEP:
(config-eth 0/1)#ethernet-cfm mep Domain1 association1 100 down
(config-eth 0/1-mep)#snmp-trap fault alarm
(config-eth 0/1-mep)#
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 3108