ADTRAN AOS Version R10.1.0 Command Reference Manual page 2997

Command Reference Guide
area <area id> stub
Use the area stub command to configure an area as a stub area. Use the no form of this command to
disable stub-designation for areas defined as stubs using this command. Variations of this command
include:
area <area id> stub
area <area id> stub no-summary
Syntax Description
<area id>
no-summary
Default Values
By default, open shortest path first (OSPF) is not enabled.
Command History
Release 3.1
Technology Review
It is important to coordinate configuration of all routers and access servers in the stub area. The area stub
command must be configured for each of those pieces of equipment. Use the area router configuration
command with the area default-cost command to specify the cost of a default internal router sent into a
stub area by an ABR. Refer to
Usage Examples
The following example configures area 2 as a stub area:
(config)#router ospf
(config-ospf)#area 2 stub
60000CRG0-35E
Specifies the identifier for this area. Specifies as an integer (range is 0 to
4294967295) or an IP address. IP addresses should be expressed in dotted
decimal notation (for example, 10.10.10.1).
Optional. Designates the area as a total stub area. No summary link
advertisements will be sent by the area border router (ABR) into the stub
area.
Command was introduced.
area <area id> default-cost <value> on page 2995
Copyright © 2012 ADTRAN, Inc.
Router (OSPF) Command Set
for related information.
2997