Table of Contents
Advertisement
Command Reference Guide
passive-interface <interface>
Use the passive-interface command to disable the transmission of routing updates on the specified
interface. Use the no form of this command to enable the transmission of routing updates on an interface.
Syntax Description
<interface>
Default Values
By default, Routing Information Protocol (RIP) is not enabled.
Command History
Release 1.1
Release A4.01
Release A5.01
Functional Notes
All routing updates received on that interface will still be processed (and advertised to other interfaces), but
no updates will be transmitted to the network connected to the specified interface. Multiple
passive-interface commands may be used to create a customized list of interfaces.
Usage Examples
The following example disables routing updates on the Frame Relay link (labeled 1.17) and the
Point-to-Point Protocol (PPP) link (labeled 1):
(config)#router rip
(config-rip)#passive-interface frame-relay 1.17
(config-rip)#passive-interface ppp 1
60000CRG0-35E
Specifies an interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface id | ap |
ap/radio | ap/radio.vap]>. For example, for a T1 interface, use t1 0/1; for an
Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for an
ATM subinterface, use atm 1.1; and for a wireless virtual access point, use
dot11ap 1/1.1. Type passive-interface ? for a complete list of valid
interfaces.
Command was introduced.
Command was expanded to include the Metro Ethernet Forum (MEF) Metro
Ethernet interface.
Command was expanded to include the Gigabit Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Router (RIP) Command Set
3028
Advertisement
Table of Contents
