Command Reference Guide
type
Use the type command to configure the group type for the operator group. Variations of this command
include:
type all
type executive
type linear
type ucd
Syntax Description
all
executive
linear
ucd
Default Values
No default values are necessary for this command.
Command History
Release 10.1
Usage Examples
The following example configures all phones in the operator ring group to ring each time a call comes in:
(config)#voice operator-group
(config-operator-group)#type all
60000CRG0-35E
Configures the group as an all-inclusive operator group. When an operator
group call comes in, all phones ring simultaneously.
Configures an executive operator group. Refer to
3414
for more information.
Configures the group as a linear hunt operator group. Member phones ring
one at a time until the call is picked up. When the next call comes in, the call
cycle begins again by ringing the first operator group member. Refer to
member <number> on page 3395
Configures the group as a uniform call distribution (UCD) operator group.
Member phones ring one at a time until the call is picked up. When the next
call comes in, the system remembers which member extension it last dialed
and then continues the call cycle by ringing the next member in the operator
group.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Voice Operator Ring Group Command Set
email <address> on page
for more information.
3399