Voice Trunk Group Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
V T
OICE RUNK
Voice trunks are digital or analog subscriber lines delivered by service providers that allow communication
devices to connect to the outside world. Voice trunk groups combine one or more trunk accounts and
assign outbound call characteristics to the group. Individual trunk groups can be created for each trunk
account. The trunk group is assigned outbound call capabilities (local calls, long distance calls, etc.).
Additionally, a cost is assigned to each attribute in the outbound call template.
To create a trunk group, you must first configure individual trunk accounts. For more information on
creating voice trunk accounts, refer to the following sections of this document:
• Voice Analog Trunk Command Set on page 3443
• Voice SIP Trunk Command Set on page 3532
• Voice T1 Trunk Command Set on page 3603
For more information about configuring trunk groups, refer to the NetVanta 7000 Series Trunk Accounts
configuration guide available online at
Integrated services digital network (ISDN) trunk groups are created using the command
isdn-group <number> on page
ISDN trunk groups, refer to the
To enter the Voice Trunk Group Configuration mode, enter the voice grouped-trunk command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#voice grouped-trunk TestGroup
(config-TestGroup)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
description <text> on page 70
do on page 71
exit on page 73
interface on page 74
60000CRG0-35E
G C
ROUP OMMAND
https://supportforums.adtran.com
Copyright © 2012 ADTRAN, Inc.
S
ET
1227. For more information regarding the creation of
Voice ISDN Group Command Set on page

Voice Trunk Group Command Set

(article number 1541).
3375.
3430