ADTRAN AOS Version R10.1.0 Command Reference Manual page 2969

Command Reference Guide
control source-port
Use the control source-port command to specify the Two-Way Active Measurement Protocol (TWAMP)
source control port. Use the no form of this command to return to the default setting. Variations of this
command include:
control source-port owamp-control
control source-port twamp-control
control source-port <port>
Syntax Description
owamp-control
twamp-control
<port>
Default Values
By default, the source port is the TWAMP control port, port 862.
Command History
Release 17.2
Release 17.6
Usage Examples
The following example specifies the OWAMP control port as the source control port for the TWAMP
responder:
(config)#probe responder twamp
(config-responder-twamp)#control source-port owamp-control
60000CRG0-35E
Specifies One-Way Active Measurement Protocol (OWAMP) control port
(861) as the source port.
Specifies the default TWAMP control port (862) as the source port.
Specifies a source TWAMP control port other than the default port 862. The
valid range is 1 to 65535.
Command was introduced.
Command was expanded to include the twamp-control parameter and the
default source port was set to port 862.
Copyright © 2012 ADTRAN, Inc.
Network Monitor Probe Responder Command Set
2969