ADTRAN AOS Version R10.1.0 Command Reference Manual page 3101

Adtran operating system (aos)
Table of Contents

Advertisement

Command Reference Guide
mp-sender-id
Use the mp-sender-id command to enable each maintenance endpoint (MEP) in this association to send
sender ID type length values (TLVs) in transmitted packets. Use the no form of this command to revert the
sender ID setting to that of the parent association. Variations of this command include:
mp-sender-id chassis-id
mp-sender-id chassis-id management-address
mp-sender-id management-address
mp-sender-id management-address chassis-id
mp-sender-id none
Syntax Description
chassis-id
management-address
none
Default Values
By default, the MEP's sender ID setting is the same as that of the parent association.
Command History
Release 17.4
Functional Notes
TLVs are included in continuity check messages (CCMs) and used in Ethernet operations, administration,
and maintenance (OAM) connectivity fault management (CFM) fault detection.
It is important to note how the chassis ID and management address are created for the system. The
chassis ID is created either from Simple Network Management Protocol (SNMP), using the command
snmp-server chassis-id <string> on page
access control (MAC) address. The management address is created either from SNMP through the
primary IP of the source interface shown in the command
page
1335, or if SNMP is not configured, using the primary IP of the MEP's interface.
For more information regarding Ethernet OAM CFM and its operation on AOS products, refer to the
Ethernet OAM CFM in AOS configuration guide available online at
(article number 3013).
Usage Examples
The following example specifies that MEPs in this association include their chassis ID in the sender ID
TLVs:
(config-ecfm-domain)#association association1
(config-ecfm-ma-comp)#mp-sender-id chassis-id
(config-ecfm-ma-comp)#
60000CRG0-35E
Specifies that the chassis IDs are transmitted.
Specifies that management addresses are transmitted.
Specifies that no sender ID is transmitted.
Command was introduced.
1318, or if SNMP is not configured, using the system medium
Copyright © 2012 ADTRAN, Inc.
Ethernet OAM CFM Command Set
snmp-server source-interface <interface> on
https://supportforums.adtran.com
3101

Advertisement

Table of Contents
loading

Related Products for ADTRAN AOS Version R10.1.0

This manual is also suitable for:

Aos r10.1.0

Table of Contents