Table of Contents
Advertisement
Command Reference Guide
remote-mep <mep id>
Use the remote-mep command to create a list of remote maintenance endpoints (MEPs) for this
association. Use the no form of this command to remove the MEP from the list.
Syntax Description
<mep id>
Default Values
By default, no remote MEPs are listed.
Command History
Release 17.4
Functional Notes
Using the remote-mep command populates the maintenance association's (MA's) remote MEP list.
Remote MEPs are MEPs not on this device, but communicate with other MEPs in the same MA. Local
MEPs, or those on the same device, are automatically listed.
Each MEP ID is stored and can be compared to the MEP's continuity check message (CCM) database
learned by listening to CCMs from other MEPs in the network. This allows each MEP to determine if it is
receiving CCMs from expected MEPs, as well as detect any unexpected MEPs in the network.
You will need to repeat this command as many times as necessary to populate the MA's
remote MEP list with all of the remote MEPs in your network.
For more information regarding Ethernet operations, administration, and maintenance (OAM) connectivity
fault management (CFM) and its operation on AOS products, refer to the Ethernet OAM CFM in AOS
configuration guide available online at
Usage Examples
The following example adds the remote MEP with the MEP ID of 1000 to this association's remote MEP
list:
(config-ecfm-domain)#association association1
(config-ecfm-assoc)#remote-mep 1000
(config-ecfm-assoc)#
60000CRG0-35E
Specifies the unique ID given to the MEP. MEP ID range is 1 to 8191.
Command was introduced.
https://supportforums.adtran.com
Copyright © 2012 ADTRAN, Inc.
Ethernet OAM CFM Command Set
(article number 3013).
3100
Advertisement
Table of Contents
