ADTRAN AOS Version R10.1.0 Command Reference Manual page 2987

Command Reference Guide
test list
Use the test list command to enter the Boolean Track Test List command set, which is used to specify
multiple objects (schedule, probe, or interface) to be tested. Use the no form of this command to remove
the test list. Variations of this command include:
test list and
test list or
The following additional subcommands are available once you have entered the Boolean Track Test List
Configuration mode:
if interface <interface> ip-routing
if interface <interface> line-protocol
if probe <name>
if schedule <name>
if not interface <interface> ip-routing
if not interface <interface> line-protocol
if not probe <name>
if not schedule <name>
When using any command under the Boolean AND/OR track test list, it is important to
remember how the logic will affect every object in the track test list.
Syntax Description
and
or
if [probe | schedule | interface]
if not [probe | schedule | interface] Specifies a single conditional test to be added to the test track list.
<interface>
ip-routing
60000CRG0-35E
Specifies the relationship between all objects placed in this list. The
logical AND relationship means that all objects in this list must be in
the PASS state for the track test list to pass, or at least one object in
a FAIL state for the track test list to fail.
Specifies the relationship between all objects placed in this list. The
logical OR relationship means that only one of the objects in this list
must be in the PASS state for the track test list to pass, and all
objects in a FAIL state for the track test list to fail.
Specifies a single conditional test to be added to the test track list.
The not keyword indicates that the individual track state will negate
the result of the object test.
Specifies the interface to be added to the test track list. Specify an
interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface id]>.
For example, for an Ethernet subinterface, use eth 0/1.1; for a PPP
interface, use ppp 1; for an ATM subinterface, use atm 1.1; and for
a virtual local area network interface, use vlan 1. Type if interface
? for a complete list of valid interfaces.
Specifies the interface's ability to perform IP routing will be tested.
Copyright © 2012 ADTRAN, Inc.
Network Monitor Track Command Set
2987