ADTRAN AOS Version R10.1.0 Command Reference Manual page 3062

Command Reference Guide
ntp-server <ipv4 address>
Use the ntp-server command to specify the name of the Network Time Protocol (NTP) server published to
the Dynamic Host Control Protocol version 4 (DHCPv4) client. Use the no form of this command to
remove a defined NTP server.
Syntax Description
<ipv4 address>
Default Values
By default, no NTP server is defined.
Command History
Release 9.1
Usage Examples
The following example specifies the IPv4 address of the NTP server:
(config)#ip dhcp pool MyPool
(config-dhcp)#ntp-server 192.168.1.1
60000CRG0-35E
Specifies the IPv4 address of the NTP server. IPv4 addresses should be
expressed in dotted decimal notation (for example, 10.10.10.1).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
DHCPv4 Pool Command Set
3062