ADTRAN AOS Version R10.1.0 Command Reference Manual page 3265

Command Reference Guide
limit time <value>
Use the limit time command to specify the time limit, in seconds, for the packet capture. This command
triggers a packet capture (Pcap) file export after the given time value is exceeded. Use the no form of this
command to return the time limit to the default value.
Syntax Description
<value>
Default Values
By default, Pcap files are set to export after 900 seconds (15 minutes).
Command History
Release R10.1.0
Functional Notes
At least one capture limit, whether size or time, must be configured with a non-zero value before the
packet-capture can be enabled. Configure a time limit using this command, or a size limit using the
command limit size <value> on page
size or time limits.
Usage Examples
The following example specifies that Pcap files are exported after 2000 seconds:
(config)#packet-capture 1CAPTURE standard
(config-packet-capture-1CAPTURE)#time limit 2000
60000CRG0-35E
Specifies the capture time limit in seconds. Valid range is 0 to 604800
seconds. Using a value of 0 disables the capture's time limit.
Command was introduced.
3264. ADTRAN recommends that you do not disable packet capture
Copyright © 2012 ADTRAN, Inc.
Packet Capture Command Set
3265