ADTRAN AOS Version R10.1.0 Command Reference Manual page 3473

Command Reference Guide
rtp delay-mode
Use the rtp delay-mode command to configure the Realtime Transport Protocol (RTP) jitter buffer packet
delay mode settings. RTP is used to prevent static on voice connections by enhancing the quality of the
packet delivery. Use the no form of this command to return to the default setting. Variations of this
command include:
rtp delay-mode adaptive
rtp delay-mode fixed
Syntax Description
adaptive
fixed
Default Values
By default, the RTP delay mode is set to adaptive. This allows for minimal latency by adjusting the
average packet delay based on the conditions of the network.
Command History
Release 11.1
Usage Examples
The following example configures RTP delay mode as fixed:
(config)#voice trunk t01 type analog supervision loop-start
(config-t01)#rtp delay-mode fixed
60000CRG0-35E
Configures the RTP jitter buffer packet delay to adjust during a call based
on network conditions.
Configures the RTP jitter buffer packet delay to remain constant.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Voice Analog Trunk Command Set
3473