ADTRAN AOS Version R10.1.0 Command Reference Manual page 2975

Command Reference Guide
source-interface <interface>
Use the source-interface command to specify an interface with the primary IP address used as the source
address for responder traffic that originated from the unit. Use the no form of this command to return to the
default setting.
Syntax Description
<interface>
Default Values
By default, the source interface is not configured.
Command History
Release 17.2
Release A4.01
Usage Examples
The following example configures the source interface as vlan1:
(config)#probe responder twamp
(config-responder-twamp)#source-interface vlan1
60000CRG0-35E
Specify an interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface id | ap |
ap/radio | ap/radio.vap]>. For example, for a T1 interface, use t1 0/1; for an
Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for an
ATM subinterface, use atm 1.1; and for a wireless virtual access point, use
dot11ap 1/1.1.
Command was introduced.
Command was expanded to include the Metro Ethernet Forum (MEF) Metro
Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Network Monitor Probe Responder Command Set
2975