Table of Contents
Advertisement
Command Reference Guide
host client-identifier
Use the host client-identifier command to create a Dynamic Host Control Protocol version 6 (DHCPv6)
host entry within the DHCPv6 Host Configuration mode. This command creates a host entry in the host
server pool and specifies the manual binding of a set of information to a single client as identified by a
DHCPv6 client ID (DUID). Use the no form of this command to remove the host client ID (DUID) from
the host server pool. Variations of this command include:
host client-identifier <client DUID>
host client-identifier <client DUID> <IAID>
Syntax Description
<client DUID>
<IAID>
Default Values
By default, no host DUID is specified.
Command History
Release R10.1.0
Functional Notes
The value specified by this command is used to allow a single device, or interface, to match the DHCPv6
server pool host.
Usage Examples
The following example creates a DHCPv6 host DUID of F2A4C9 in the DHCPv6 Host Configuration mode:
(config-dhcpv6)#host client-identifier F2A4C9
(config-dhcpv6-host)#host client-identifier F2A4C8
60000CRG0-35E
Specifies the DUID of the client to be matched as a DHCPv6 host. The
DUID is expressed as a hexadecimal value.
Optional. Specifies a hexadecimal value that represents the IAID expected
in the DHCPv6 client request.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
DHCPv6 Server Pool Host Command Set
3089
Advertisement
Table of Contents
