Table of Contents
Advertisement
Command Reference Guide
sntp-server <ipv6 address>
Use the sntp-server command to specify the unicast Internet Protocol version 6 (IPv6) address of a Simple
Network Time Protocol (SNTP) server to be supplied to requesting Dynamic Host Control Protocol
version 6 (DHCPv6) clients served by this pool. Use the no form of this command to remove the server
address from the pool. If no server address is specified when using the no form of this command, all SNTP
server addresses are removed from the pool.
Syntax Description
<ipv6 address>
Default Values
By default, no SNTP information is specified or sent to the DHCPv6 client.
Command History
Release 18.3
Functional Notes
Multiple SNTP server addresses can be entered using multiple instances of this command. Each address
is added or deleted individually. Up to 50 addresses can be entered. These addresses are assigned in the
order they are entered. If the no version of this command is entered without specifying an address, all
addresses are removed from the pool.
Usage Examples
The following example adds an SNTP server to the DHCPv6 pool:
(config)#ipv6 dhcp pool MyPool1
(config-dhcpv6)#sntp-server 2001:DB8:1::1
60000CRG0-35E
Specifies the IPv6 address of the SNTP server. IPv6 addresses should be
expressed in colon hexadecimal format (X:X:X:X::X). For example,
2001:DB8:1::1.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
DHCPv6 Pool Command Set
3083
Advertisement
Table of Contents
