Ip Routing Policy Configuration Commands; Apply Cost - H3C s3600 series Command Manual

5

IP Routing Policy Configuration Commands

The term router in this chapter refers to a router in a generic sense or an Ethernet switch running a
routing protocol.
IP Routing Policy Configuration Commands

apply cost

Syntax
apply cost value
undo apply cost
View
Route policy view
Parameters
value: Cost for matched routes, in the range of 0 to 4294967295.
Description
Use the apply cost command to apply a cost to routes satisfying matching rules.
Use the undo apply cost command to remove the configuration.
By default, no cost is applied to routes satisfying matching rules.
The apply clause is one that sets a cost for the routes satisfying matching rules in a routing policy.
Related commands: if-match interface, if-match acl, if-match ip-prefix, if-match ip next-hop,
if-match cost, if-match tag, route-policy, apply tag.
Examples
# Create a routing policy named policy and node 1 with the matching mode being permit. Apply the
cost 120 to routes matching ACL 2000.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] route-policy policy permit node 1
%New sequence of this list
[Sysname-route-policy] if-match acl 2000
[Sysname-route-policy] apply cost 120
5-1