Rip Version - H3C s3600 series Command Manual

Parameters
None
Description
Use the rip split-horizon command to enable the split horizon function.
Use the undo rip split-horizon command to disable the split horizon function.
By default, the split horizon function is enabled.
The split horizon function disables an interface from sending routes received from the interface to
prevent routing loops between adjacent routers. Therefore, normally, split horizon is necessary for
avoiding routing loops. Only in some special cases the split horizon function needs to be disabled to
ensure the correct execution of the protocol. So, disable the split horizon function only when necessary.
Examples
# Disable the split horizon function on the interface VLAN-interface 10.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] undo rip split-horizon

rip version

Syntax
rip version { 1 | 2 [ broadcast | multicast ] }
undo rip version
View
Interface view
Parameters
1: Specifies the version of RIP running on an interface as RIP-1.
2: Specifies the version of RIP running on an interface as RIP-2.
broadcast: Sends RIP-2 packets in the broadcast mode.
multicast: Sends RIP-2 packets in the multicast mode.
Description
Use the rip version command to specify the version of RIP running on an interface.
Use the undo rip version command to restore the default.
By default, the version of RIP running on an interface is RIP-1 and RIP-1 packets are sent in the
broadcast mode.
If RIP-2 runs on an interface, RIP packets are sent in the multicast mode by default, which reduces
resource consumption.
3-16