Mc3000 Display; Mc3000 Display In Stop Mode - Lenze AC Tech M3103S Installation & Operation Manual

13 .2 MC3000 DISPLAY
The following describes the possible display configurations for the MC3000 Series drive
when operating as a standard drive (without PID control) . Refer to Section 19 - MC3000
PID SETPOINT CONTROL for a complete description of drive operation when using
PID control .
13 .2 .1 MC3000 DISPLAY IN STOP MODE
When the drive is in the STOP mode, there are three possible displays . The first is the
SPEED display, which looks like this:
NOTE
Refer to Parameter 31 - UNITS for the SPEED UNITS display options .
Pressing the ENTER key will change the display from the SPEED indication to the %
LOAD indication:
Pressing the ENTER key again will change the display from the % LOAD indication to
the VAC (motor voltage) indication:
Pressing ENTER again will change the display back to the SPEED indication .
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
DRIVE SPEED
STATUS
SETPOINT
STOP > 60.00 HZ
DIRECTION
(FORWARD)
DRIVE
STATUS
STOP > 0% LOAD
DIRECTION
(FORWARD)
DRIVE
STATUS
STOP >
DIRECTION
(FORWARD)
M301L
SPEED
UNITS
PERCENT
LOAD
MOTOR
VOLTAGE
0 VAC
25