Frame-Relay Lmi-N391Dte - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
frame-relay lmi-n391dte
Syntax
Release Information
Description
Options
Mode
642
frame-relay lmi-n391dte keepExchanges
no frame-relay lmi-n391dte
Command introduced before JunosE Release 7.1.0.
Sets the full-status polling counter (N391) on a DTE interface. The no version restores
the default value, assuming an LMI has been configured.
keepExchanges—Number in the range 1– 255; default value is 6; number of keep
exchanges to be done before requesting a full-status message. If you specify a value
of 1, you receive full-status messages only.
Interface Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
