Reset Isis All - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
[Sysname-isis-1] network-entity 10.0001.1010.1020.1030.00
4.1.49 preference
Syntax
preference { route-policy route-policy-name | preference } *
undo preference
View
IS-IS view
Parameters
preference: Specifies the preference for IS-IS protocol, ranging from 1 to 255.
route-policy-name: Routing policy name, a string of 1 to 19 characters. The preference
applies to routes passing the routing policy.
Description
Use the preference command to configure the preference for IS-IS protocol.
Use the undo preference command to restore the default.
By default, the IS-IS protocol preference is 15.
If a routing policy is specified in this command, the preference (if any) set by the routing
policy applies to those matched routes. Other routes use the preference set by the
preference command.
When a router runs multiple routing protocols at the same time, the system will set a
preference to each routing protocol. If several protocols find routes to the same
destination, the route of the routing protocol with the highest preference is selected.
Examples
# Configure the preference of IS-IS protocol as 25.
<Sysname> system-view
[Sysname] isis
[Sysname-isis-1] preference 25

4.1.50 reset isis all

Syntax
reset isis all [ process-id ]
View
User view
Chapter 4 IS-IS Configuration Commands
4-50