Revision-Level; Stp - H3C MSR 20-20 Command Reference Manual

revision-level

Syntax
View
Parameters
Description
Related commands:
Examples

stp

Syntax
View
Parameters
Description
revision-level level
undo revision-level
MST region view
level: MSTP revision level, in the range of 0 to 65535. The system default is 0.
Use the
region-level
device.
Use the undo region-level
default setting.
The MSTP revision level, the MST region name and the VLAN-to-instance mapping
table of a device jointly determine the MST region the device belongs to.
instance, region-name, check region-configuration, vlan-mapping modulo,
and active region-configuration.
# Set the MSTP revision level of the MST region to 5.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] revision-level 5
stp { enable | disable }
undo stp
System view, Ethernet interface view, port group view
enable: Enables the MSTP feature.
disable: Disables the MSTP feature.
Use the command to enable or disable the MSTP feature globally or for a port
stp
or a group of ports.
Use the undo stp command to restore the default MSTP status globally or for a
port or a group of ports.
By default, MSTP is enabled for all ports, and disabled globally.
Note that:
command to configure the MSTP revision level of your
command to restore the MSTP revision level to the
607