Isdn Link-Mode; Isdn Number-Property - H3C MSR 20-20 Command Reference Manual

578 C 37: ISDN C
HAPTER
Description
Example

isdn link-mode

Syntax
View
Parameter
Description
Example

isdn number-property

Syntax
View
Parameter
C
ONFIGURATION OMMANDS
Use the isdn L3-timer
L3 timer. Use the undo isdn L3-timer command to restore the default duration of
the ISDN L3 timer on the interface.
You can view the default durations of the L3 timers in the ISDN protocol by
executing the display isdn parameters command.
# Set the duration of the L3 timer T301 on the interface BRI 1/0 to 160 seconds.
<Sysname> system-view
[Sysname] interface bri 1/0
[Sysname-Bri1/0] isdn l3-timer t301 160
isdn link-mode p2p
undo isdn link-mode
ISDN BRI interface
None
Use the isdn link-mode p2p
the point-to-point mode.
Use the
undo isdn link-mode
operating mode.
By default, a BRI interface operates in the point-to-multipoint mode, in which a
BRI interface operating on the network side can have multiple end devices
attached to it.
# Configure BRI1/0 interface to operate in the point-to-point mode.
<Sysname> system-view
[Sysname] interface bri 1/0
[Sysname-Bri1/0] isdn link-mode p2p
isdn number-property number-property [ calling | called ] [ in | out ]
undo isdn number-property [ calling | called ] [ in | out ]
ISDN interface view
number-property: Type and number scheme of ISDN numbers. The argument takes
on a hex value in the range of 0 to 7F. When it is expressed in 8 bits, bits 1 through
4 represent the code scheme, bits 5 through 7 represent the code type, and bit 8 is
command to configure the duration of an ISDN protocol
command to configure a BRI interface to operate in
command to restore the default BRI interface