Bridging Configuration Commands; Bridge Aging-Time; Bridge Bridge-Set Enable - H3C MSR 20-20 Command Reference Manual

36

bridge aging-time

Syntax
View
Parameters
Description
Example

bridge bridge-set enable

Syntax
View
Parameters
Description
B
RIDGING
C
OMMANDS
bridge aging-time seconds
undo bridge aging-time
System view
seconds: Aging time of dynamic bridge table entries, in seconds, with an effective
range of 10 to 1000000.
Use the
bridge aging-time
bridge table entries.
Use the
undo bridge aging-time
By default, the aging time of dynamic bridge table entries is 300 seconds.
# Set the aging time of dynamic bridge table entries to 500 seconds.
<Sysname> system-view
[Sysname] bridge aging-time 500
bridge bridge-set enable
undo bridge bridge-set enable
System view
bridge-set: Bridge set number, an integer in the range of 1 to 255.
Use the
bridge
Use the
undo bridge
n
Before you can enable the bridge set feature, you need to enable bridging first.
■
Other related configurations can take effect only if the bridging and bridge set
■
features are enabled. This command is required for bridge configuration.
C
ONFIGURATION
command to configure the aging time of dynamic
command to restore the default setting.
bridge-set enable command to enable a bridge set.
bridge-set enable command to remove a bridge set.