Interface Bridge-Template - H3C MSR 20-20 Command Reference Manual

Description
Related command:
Example

interface bridge-template

Syntax
View
Parameters
Description
Related command:
Example
broadcast: Specifies to allow bridging of broadcasts over this FR-to-bridging
mapping.
Use the
fr map bridge
specified virtual circuit.
Use the
undo fr map bridge
By default, no FR-to-bridging mappings exist.
display fr map-info on page 376.
# Create an FR-to-bridging mapping on the virtual circuit by the DLCI of 50 on
Serial2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] link-protocol fr
[Sysname-Serial2/0] fr interface-type dce
[Sysname-Serial2/0] fr dlci 50
[Sysname-Serial2/0] bridge-set 1
[Sysname-Serial2/0] fr map bridge 50 broadcast
interface bridge-template bridge-set
undo interface bridge-template bridge-set
System view
bridge-set: Bridge set number, an integer in the range of 1 to 255.
Use the
interface bridge-template
interface for a bridge set.
Use the
undo interface bridge-template
bridge-template interface.
A bridge set can have only one bridge-template interface.
bridge routing-enable.
# Create a bridge-template interface for bridge set 1.
<Sysname> system-view
[Sysname] interface bridge-template 1
[Sysname-Bridge-template1]
command to create an FR-to-bridging mapping on the
command to remove an FR-to-bridging mapping.
command to create a bridge-template
command to remove a
559