Bridge Routing-Enable; Bridge-Set - H3C MSR 20-20 Command Reference Manual

bridge routing-enable

Syntax
View
Parameters
Description
Example

bridge-set

Syntax
View
Parameters
Description
Example
bridge routing-enable
undo bridge routing-enable
System view
None
Use the
bridge routing-enable
Use the undo bridge routing-enable
By default, bridge routing is disabled.
Routing of a particular protocol can be implemented only if bridge routing is
enabled.
# Enable bridge routing.
<Sysname> system-view
[Sysname] bridge routing-enable
bridge-set bridge-set
undo bridge-set bridge-set
Interface view
bridge-set: Bridge set number, an integer in the range of 1 to 255.
Use the bridge-set
Use the
undo bridge-set
bridge set.
By default, a bridge set does not contain any interface.
# Add Ethernet1/0 into bridge set 1.
<Sysname> system-view
[Sysname] interface ethernet1/0
[Sysname-Ethernet1/0] bridge-set 1
Promiscuous operation mode was set automatically.
n
As shown above, after being added into bridge set 1, Ethernet1/0
■
automatically works in the promiscuous operation mode. When working in the
command to enable bridge routing.
command to disable bridge routing.
command to add the current interface into a bridge set.
command to remove the current interface from a
553