Bridge Routing - H3C MSR 20-20 Command Reference Manual

552 C 36: B
HAPTER RIDGING
Description
Example

bridge routing

Syntax
View
Parameters
Description
Example
C C
ONFIGURATION OMMANDS
deny: Discards frames whose source address or destination address is the
specified address on all interfaces or the specified interface.
permit: Forwards frames whose source address or destination address is the
specified address on all interfaces or the specified interface.
interface: Specifies an outbound interface.
interface-type interface-number: Specifies an interface by its name and number.
dlsw: Specified that the outbound interface is a DLSw module.
Use the bridge mac-address
Use the
undo bridge mac-address
entry.
# Configure a static bridge table entry so that Ethernet1/0 can forward frames
with a destination MAC address of 0000-0000-0111.
<Sysname> system-view
[Sysname] bridge 1 mac-address 0000-0000-0111 permit interface ethernet 1/0
bridge bridge-set routing { ip | ipx }
undo bridge bridge-set routing { ip | ipx }
System view
bridge-set: Bridge set number, an integer in the range of 1 to 255.
ip: Specifies the Internet protocol (IP).
ipx: Specifies the internetwork packet exchange (IPX) protocol.
Use the bridge routing
on the specified bridge set.
Use the
undo bridge routing
protocol(s) on the specified bridge set.
By default, routing of network layer protocols is disabled.
If the bridge set is configured to route the specified protocol, the packets of the
protocol that need to be routed will be routed.
# Enable IP routing in bridge set 1.
<Sysname> system-view
[Sysname] bridge 1 routing ip
command to configure a static bridge table entry.
command to remove a static bridge table
command to enable routing of the specified protocol(s)
command to disable routing of the specified