Display Isdn Spid - H3C MSR 20-20 Command Reference Manual

568 C 37: ISDN C
HAPTER

display isdn spid

Syntax
View
Parameter
Description
Example
C
ONFIGURATION OMMANDS
T321
T322
Table 97 Description of the fields of the display isdn parameters command
Item
T200(sec)
T201(sec)
T202(sec)
T203(sec)
N200
K(BRI)
K(PRI)
Timer-Number
Value(sec)
display isdn spid [ interface interface-type interface-number ]
Any view
interface-type interface-number: Specifies an interface by its type and number.
Use the
display isdn spid
interface encapsulated with the NI protocol.
You may execute this command to view the SPID type, SPID value and some other
information when ISDN is running. Executing this command without specifying an
interface, you may view information on SPI on all the SPID-supported BRI
interfaces.
# Display the related information of SPID on the NI-supported interface BRI 1/0.
<Sysname> display isdn spid interface bri 1/0
Interface Bri1/0 :
SPID Type: AUTO
SPID B1:
SPID Num:
Neg State: SPID_UNASSIGNED
Init State: INIT_NULL
SPID B2:
SPID Num:
Neg State: SPID_UNASSIGNED
Init State: INIT_NULL
30
4
Description
Retransmit-timer (in seconds) of the L2 protocol of ISDN
TEI test request retransmit-timer (in seconds) of the L2 protocol of
ISDN
TEI request retransmit-timer (in seconds) of the ISDN L2 protocol
The maximum link idle time (in seconds) of the ISDN L2 protocol
The maximum number of retransmissions
The maximum number of unacknowledged frames (slide window
size) on the ISDN BRI port
The maximum number of unacknowledged frames (slide window
size) on the ISDN PRI port
ISDN L3 timer
Duration (in seconds) of each ISDN L3 timer
command to view information on SPID on the BRI