Isdn L3-Timer - H3C MSR 20-20 Command Reference Manual

Example

isdn L3-timer

Syntax
View
Parameter
executing the shutdown command, configure the command, and then enable
the interface by executing the undo shutdown command. The operations,
however, will lead to the disconnection of the call existing on the interface.
You can configure this command on an interface only when the ISDN protocol
running on the interface is DSS1, Q.SIG, NI2, or ETSI.
# Ignore the Sending Complete Information Element in the received SETUP
messages.
<Sysname> system-view
[Sysname] interface bri 1/0
[Sysname-Bri1/0] isdn ignore sending-complete incoming
# Disable carrying the Sending Complete Information Element in the transmitted
SETUP messages.
[Sysname-Bri1/0] isdn ignore sending-complete outgoing
isdn L3-timer timer-name time-interval
undo isdn L3-timer { all | timer-name }
ISDN interface view
timer-name: Name of a L3 timer of the ISDN protocol.
time-interval: Timer duration, which can take on one of the values listed in the
following table.
all: Restores the default durations of all the L3 timers.
Table 99 Description of Q931 timers
timer-name Timer-name
t301 T301
t302 T302
t303 T303
t304 T304
t305 T305
t308 T308
t309 T309
t310 T310
t313 T313
t316 T316
t322 T322
Value range (in Default (in
seconds) seconds)
30 to 1200 240
5 to 60 15
2 to 10 4
10 to 60 30
4 to 30 30
2 to 10 4
10 to 180 90
10 to 180 40
2 to 10 4
20 to 180 120
2 to 10 4
577