Reset Bridge Address-Table; Reset Bridge Traffic - H3C MSR 20-20 Command Reference Manual

Example

reset bridge address-table

Syntax
View
Parameters
Description
Example

reset bridge traffic

Syntax
View
Parameters
Description
By default, bridging over a PVC is disabled. If you configure both the map bridge
virtual-ethernet and map bridge-group commands, only the map bridge
virtual-ethernet takes effect.
# Enable bridging over PVC 32/102.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-Atm1/0] pvc 32/102
[Sysname-atm-pvc-Atm1/0-32/102] map bridge-group broadcast
reset bridge address-table [ bridge-set bridge-set | dlsw | interface interface-type
interface-number ]
User view
bridge-set: Clears MAC address entries of the specified bridge set. bridge-set must
be an integer in the range of 1 to 255.
dlsw: Clears MAC address entries of the DLSw module.
interface-type interface-number: Clears MAC address entry of the specified
interface.
Use the
reset bridge address-table
bridge table entries.
# Clear all dynamic entries about bridge set 1 from the bridge table.
<Sysname> reset bridge address-table bridge-set 1
reset bridge traffic [ bridge-set bridge-set | dlsw | interface interface-type
interface-number ]
User view
bridge-set: Clears traffic statistics information about the specified bridge set.
bridge-set must be an integer in the range of 1 to 255.
dlsw: Clears the traffic statistics information about the DLSw module.
interface-type interface-number: Clears the traffic statistics information about the
specified interface.
Use the reset bridge traffic
bridged traffic.
command to remove one or more dynamic
command to clear the statistic information about
561