Slave Switch Configuration; Displaying And Debugging A Stack - H3C S3100-52P Operation Manual

Operation Manual – Stack-Cluster
H3C S3100-52P Ethernet Switch
join-in requests to the connected stack ports of all the switches connected with the
device. This may cause switches not expecting to join in the stack to join in the stack
automatically, affecting network stability.
You can configure the stack-port function on the stack ports that are connected with
other switches to choose whether to send join-in requests to the switches, so as to
prevent the switches that do not belong to the local stack from joining in.
II. Stack-Port Function Configuration
Follow these steps to configure the stack port function:
To do...
Enter system view
Enter port view
Enable the
stack-port function
on the stack port

1.3 Slave Switch Configuration

Just make sure the slave switch is connected to the main switch through the stack ports.
No configuration is needed.

1.4 Displaying and Debugging a Stack

Use the display command to display the information about a stack. The display
command can be executed in any view.
Use the command...
system-view
interface interface-type
interface-number
stack-port enable
1-4
Chapter 1 Stack
Remarks
—
—
Required
Enabled by default.
After a switch joins in a stack or
becomes the master switch of a
stack, the switch will
send/forward stack join-in
requests through this stack port.