Bridge Bridging; Bridge Enable - H3C MSR 20-20 Command Reference Manual

550 C 36: B
HAPTER RIDGING
Example

bridge bridging

Syntax
View
Parameters
Description
Example

bridge enable

Syntax
View
Parameters
C C
ONFIGURATION OMMANDS
# Enable bridge set 1.
<Sysname> system-view
[Sysname] bridge 1 enable
bridge bridge-set bridging { ip | ipx | others }
undo bridge bridge-set bridging { ip | ipx | others }
System view
bridge-set: Bridge set number, an integer in the range of 1 to 255.
ip: Specifies the Internet protocol (IP).
ipx: Specifies the internetwork packet exchange (IPX) protocol.
others: Specifies other protocols than IP and IPX.
Use the
bridge bridging
layer protocol(s) on the specified bridge set.
Use the undo bridge bridging
network layer protocol(s) on the specified bridge set.
By default, bridging of all network layer protocols is enabled.
Note that non-routable packets will be discarded if bridging of IP or IPX is disabled
in a bridge set.
# Disable IP bridging on bridge set 1.
<Sysname> system-view
[Sysname] undo bridge 1 bridging ip
# Enable IP bridging on bridge set 1.
<Sysname> system-view
[Sysname] bridge 1 bridging ip
bridge enable
undo bridge enable
System view
None
command to enable bridging of the specified network
command to disable bridging of the specified