Display Bridge Information - H3C MSR 20-20 Command Reference Manual

display bridge information

Syntax
View
Parameters
Description
Example
Table 90 Description on the fields of the display bridge address-table command
Field
Set
Flag
Aging-time
Receive
Send
Interface-name
display bridge information [ bridge-set bridge-set ]
Any view
bridge-set: Bridge set number, an integer in the range of 1 to 255.
Use the display bridge information
the specified bridge set or all bridge sets.
# View the information about all bridge sets.
<Sysname> display bridge information
Bridge module is activated,2 port take part in bridge module at all;
Address table has 15 item, with
Bridge set 1 :
configure :bridge 1 enable;
bridging ip, undo bridging ipx; bridging others;
undo routing ip, undo routing ipx;
bridge 1 learning
interface :total 2 interface(s) in the set
Ethernet1/0 : up
Ethernet1/1 : up
Bridge set 2 :
configure :bridge 2 enable;
bridging ip, undo bridging ipx; bridging others;
undo routing ip, undo routing ipx;
bridge 2 learning
interface :total 2 interface(s) in the set
Ethernet1/0.1 :up
Ethernet1/0.2 :up
Description
Bridge set number
Flag can be any of the four values: P--PERMIT N--DENY
D--DYNAMIC S--STATIC
P: The permit rule is used for MAC address filtering
N: The deny rule is used for MAC address filtering
D: This entry is a dynamic entry
S: This entry is a static entry
The aging time of bridge table entries
Number of received frames destined for this MAC address
Number of forwarded frames destined for this MAC address
Outbound interface name
command to view the information about
1 static one; life cycle is 300 (s).
555