X25 Map Bridge - H3C MSR 20-20 Command Reference Manual

562 C 36: B
HAPTER RIDGING
Example

x25 map bridge

Syntax
View
Parameters
Description
Related command:
Example
C C
ONFIGURATION OMMANDS
# Clear the traffic statistics information about bridge set 1.
<Sysname> reset bridge traffic bridge-set 1
x25 map bridge x121-address x.121-address broadcast
undo x25 map bridge x121-address x.121-address
Interface view
x121-address x.121-address: X.121 address of the peer host.
broadcast: Enables bridging of broadcasts to the X.25 destination.
Use the
x25 map bridge
Use the
undo x25 map bridge
mapping.
By default, no X.25-to-bridging mappings exist.
display x25 map on page 426.
# Create an X.25-to-bridging mapping on Serial2/0.
<Sysname> system-view
[Sysname] interface serial 1/0
[Sysname-Serial1/0] link-protocol x25
[Sysname-Serial1/0] x25 x121-address 100
[Sysname-Serial1/0] x25 map bridge x121-address 20112451 broadcast
[Sysname-Serial1/0] bridge-set 1
command to create an X.25-to-bridging mapping.
command to remove an X25-to-bridging