Replacing The Process Turning Disc - ABB IRB 6700 Series Product Manual

4.5.4 Replacing the process turning disc

Location of the process turning disc
The process turning disc is located in the front of the wrist housing as shown in
the figure.
Required tools and equipment
Equipment, etc.
Standard toolkit
Consumables
Equipment, etc.
Rust preventive
Removing the process turning disc
Use these procedures to remove the process turning disc.
Preparations before removing the process turning disc
1
Product manual - IRB 6700
3HAC044266-001 Revision: N
Action
Run the robot to a position most comfort-
able for the removal of the process turning
disc.
© Copyright 2013 - 2018 ABB. All rights reserved.
4.5.4 Replacing the process turning disc
Article number Note
- Content is defined in section
toolkit on page
Article number
-
Note
4 Repair
Standard
829.
Note
Mercasol, used on Foundry
Plus
Continues on next page
371