ABB IRB 6700 Series Product Manual page 721

Refitting the gearbox
Use this procedure to refit the gearbox.
1
2
3
4
5
6
7
8
9
Product manual - IRB 6700
3HAC044266-001 Revision: N
4.8.4 Replacing the axis-2 gearbox (IRB 6700 - 300/2.70, IRB 6700 - 245/3.00)
Action
CAUTION
The gearbox weighs according to vari-
ant110 kg.
All lifting accessories used must be sized
accordingly!
Apply the lifting accessory to the gearbox.
Use caution and lift the gearbox so that it
rests on its side.
Remove the o-ring and wipe it clean.
Note
This must also be done on a new spare
part!
Wipe clean the contact surfaces from any
contamination.
Note
Also wipe clean the o-ring groove.
Check the condition of the o-ring.
Replace if damaged.
Lubricate the o-ring with some grease, for
a better fitting in the groove.
Fit the o-ring in the groove.
Foundry Plus:
Apply Mercasol on the surfaces shown in
the figure.
© Copyright 2013 - 2018 ABB. All rights reserved.
Note
Lifting accessory, gearbox:
i
3HAC046112-001
ii
3HAC046128-001
xx1400000374
Continues on next page
4 Repair
Continued
721