ABB IRB 6700 Series Product Manual page 652

4 Repair
4.8.2 Replacing the axis-1 gearbox (IRB 6700 - 300/2.70, IRB 6700 - 245/3.00)
Continued
6
7
8
Refitting the arm system
1
2
Continues on next page
652
Action
Apply flange sealant in two strings according
to the figure.
Apply some grease on:
• the outside of the bearing
• the guiding part of the bearing
• the edge of the protection tube
• the edge around the gearbox.
Apply guide pins in the guide pin holes in the
gearbox.
Tip
Lubricate the guide pins with some grease
to make the frame slide better.
Action
CAUTION
The arm system weighs 1300 Kg.
All lifting accessories used must be sized
accordingly!
Make sure that all lifting accessories still is
fitted correctly on the arm system.
© Copyright 2013 - 2018 ABB. All rights reserved.
Note
Flange sealant, Loctite 574: 12340011-
116.
xx1700000415
Guide pin, M16x120: 3HAC062397-001 (2
pcs).
Always use guide pins in pairs.
xx1700000329
Note
See Attachment points of lifting accessory
on page 212.
Product manual - IRB 6700
3HAC044266-001 Revision: N