Changing Oil, Axis-3 Gearbox - ABB IRB 6700 Series Product Manual

3 Maintenance

3.4.4 Changing oil, axis-3 gearbox

3.4.4 Changing oil, axis-3 gearbox
Usage of oil dispenser
The oil change procedure in this section describes usage of an oil dispenser.
Location of oil plugs
The oil plugs of the gearbox are located as shown in the figure.
xx1200000954
Oil hole with nipple
Used for both draining and filling with an oil
dispenser.
Tightening torque: 24 Nm.
Required tools and equipment
Equipment, etc.
Oil collecting vessel
Oil dispenser
Standard toolkit
Continues on next page
170
Article number
-
-
-
© Copyright 2013 - 2018 ABB. All rights reserved.
IRB 6700 - 235/2.65, IRB 6700 - 205/2.80, IRB
6700 - 175/3.05, IRB 6700 - 150/3.20, IRB
6700 - 200/2.60, IRB 6700 - 155/2.85
xx1200000955
IRB 6700 - 300/2.70, IRB 6700 - 245/3.00
xx1500001645
Level/vent plug
Tightening torque: 24 Nm.
Note
The capacity of the vessel must be
sufficient to take the complete amount
of oil.
One example of oil dispenser can be
found in section Type of lubrication in
gearboxes on page
Content is defined in section
toolkit on page 829.
Product manual - IRB 6700
3HAC044266-001 Revision: N
156.
Standard