ABB IRB 6700 Series Product Manual page 495

4
5
6
7
8
9
10
Product manual - IRB 6700
3HAC044266-001 Revision: N
Action
Fit the press tool to the rear of the balancing
device with enclosed bolts. Tighten them with
45 Nm!
Fit the hydraulic cylinder to the press tool.
Connect the hydraulic pump to the cylinder.
Increase the pressure and press until the
marking on the moving pin indicates the cor-
rect position (in level with the pressure block).
Turn the fix plate to position "Closed" in order
to lock the tool in loaded condition.
Unload the hydraulic cylinder.
The hydraulic cylinder may now be removed
from the tool, when necessary.
CAUTION
Do not remove the press tool!
© Copyright 2013 - 2018 ABB. All rights reserved.
4.6.4 Unloading the balancing device
Note
Hydraulic press tool, balancing device:
3HAC020902-001.
xx0200000174
A Press block
B Hydraulic cylinder
C Press device
D Bolt, press device
E Moving pin with marking
F Bolt (4 pcs)
G Pin, attached to the fix plate
Hydraulic cylinder: 3HAC11731-1.
Hydraulic pump 80 MPa: 3HAC13086-1.
Do not apply more pressure than neces-
sary, it could damage bearings and
sealings at the shaft.
4 Repair
Continued
495