ABB IRB 6700 Series Product Manual page 267

2
3
4
Product manual - IRB 6700
3HAC044266-001 Revision: N
Action
Run the upper end of the cable harness up
through the lower arm.
Refit the axis-2 lower arm metal clamp
located on the inside of the lower arm.
Note
The screws are reached from the outside
of the lower arm.
Before fitting the remaining axis-3 lower
arm cable bracket inside the lower arm,
check that it will stay twisted a little
between the metal clamps, after fitting, as
shown in the figure. Do not change the po-
sition of the brackets!
© Copyright 2013 - 2018 ABB. All rights reserved.
4.4.2 Refitting the cable harness
Note
xx1300000733
xx1300000734
xx1300000595
Continues on next page
4 Repair
Continued
267