ABB IRB 6700 Series Product Manual page 418

4 Repair
4.5.5 Replacing the lower arm
Continued
6
7
8
i
ii
iii IRB 6700 - 300/2.70, IRB 6700 - 245/3.00
Refitting the cable harness - lower arm
1
2
Continues on next page
418
Action
Insert and tighten 20 of the 22 M16 screws.
Remove the guide pins and fit the two re-
maining screws.
Secure the upper arm by tightening the at-
tachment screws.
IRB 6700 - 235/2.65, IRB 6700 - 205/2.80, IRB 6700 - 175/3.05, IRB 6700 - 150/3.20
IRB 6700 - 200/2.60, IRB 6700 - 155/2.85
Action
Tip
Use tape and tie the axis-5 and axis-6
connectors and carrier into a bundle (if not
already done). This is done to facilitate the
procedure and to avoid damaging the parts
during the procedure.
This will also make it easier to run the cable
harness through the inside of the robot.
Run the upper end of the cable harness up
through the lower arm.
© Copyright 2013 - 2018 ABB. All rights reserved.
Note
xx1700000057
M16, tightening torque: 300 Nm
Note
xx1300000668
xx1300000733
Product manual - IRB 6700
3HAC044266-001 Revision: N