ABB IRB 6700 Series Product Manual page 497

F
G
Required equipment
Equipment, etc.
Hydraulic cylinder
Hydraulic pump 80 MPa
Standard toolkit
Consumables
Equipment, etc.
Flange sealant for conical
fittings
Restoring the balancing device
The procedure below details how to restore the balancing device, that is removing
the press tool.
1
2
3
4
5
Product manual - IRB 6700
3HAC044266-001 Revision: N
Bolt (4 pcs)
Pin, attached to the fix plate
Article number
3HAC11731-1
3HAC13086-1
-
Art. no.
-
Action
Refit the hydraulic cylinder to the press
tool, in case it has been removed.
Press with the cylinder and the hydraulic
pump until the fix plate is movable again.
Turn the pin on the fix plate to position
"Open".
CAUTION
Do not apply more pressure than neces-
sary, it could damage bearings and seal-
ings at the shaft.
Unload the hydraulic cylinder and make
sure the moving pin indicates that the tool
has returned to its starting position.
Remove the hydraulic cylinder.
Remove the press tool by unscrewing the
bolts.
© Copyright 2013 - 2018 ABB. All rights reserved.
4.6.5 Restoring the balancing device
Note
To be used with the press tool.
To be used with the hydraulic cylinder.
Content is defined in section
toolkit on page 829.
Note
Loctite 577
Used to secure the attachment screws
of the rear cover at the end of the bal-
ancing device.
Note
xx0200000174
A Press block
B Hydraulic cylinder
C Press device
D Bolt, press device
E Moving pin with marking
F Bolt (4 pcs)
G Pin, attached to the fix plate
Continues on next page
4 Repair
Continued
Standard
497