Fitting The Process Turning Disc - ABB DressPack IRB 6700 Product Manual

2 Installation

2.5 Fitting the process turning disc

2.5 Fitting the process turning disc
About the figures
When visual differences between variants, is of no importance, only one of the
versions is shown in the figures.
Location of the process turning disc
The process turning disc is located in the front of the wrist housing as shown in
the figure.
xx1400001391
Required tools and equipment
Equipment, etc.
Standard toolkit
Continues on next page
84
Note
Article number
-
© Copyright 2014-2017 ABB. All rights reserved.
Note
Content is defined in section
toolkit on page 217.
Product manual - DressPack/SpotPack IRB 6700
3HAC044270-001 Revision: F
Standard