Forwarding-Table Route-Holddown - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
forwarding-table route-holddown
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
forwarding-table route-holddown timerValue
no forwarding-table route-holddown
Command introduced before JunosE Release 7.1.0.
Sets the number of seconds allowed after a routing table change for the accumulation
of additional updates and subsequent distribution of the set of routing table changes to
the line modules. The no version sets the hold-down time to the default value (3 seconds).
timerValue—Number of seconds allowed for the accumulation and subsequent
distribution of routing table updates to the line modules; a range of 0-30 seconds,
where 0 specifies an update following each routing table change
Global Configuration
Chapter 7: F Commands
633
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers