Table of Contents
Advertisement
NOTE: The exception http-redirect command is not supported for the ES2 10G
Uplink LM.
An exception rule in the input policy only takes effect if neither the input policy nor
the secondary policy drops the packet. Packets dropped by input or secondary policies
are not exceptioned to the SRP module. HTTP redirect is the only application that is
available as a destination of the exception rule.
Because classifier groups can contain multiple actions, the following list describes
how each rule interacts with the exception rule:
Related Topics
Defining Policy Rules for Forwarding
The forward next-hop command defines a rule that creates the forwarding solution
for packets matching the current CLACL.The forward command can be used while
the policy list is referenced by interfaces. The suspend version suspends the forward
rule within the classifier group.
For IP policy lists only:
color Packets are colored and the exception rule is applied.
filter Packets are filtered and the exception rule is not applied. When the filter
rule is present, other rules are not applied.
forward Forward rule is ignored and the exception rule is applied to packets.
log Packets are logged and the exception rule is applied.
mark Packets are marked and the exception rule is applied.
next-hop Next-hop rule is ignored and the exception rule is applied to packets.
next-interface Next-interface rule is ignored and the exception rule is applied
to packets.
rate-limit-profile Rate limit is applied and the exception rule is applied to
packets.
traffic-class Traffic class is set and the exception rule is applied to packets.
user-packet-class User packet class is set and the exception rule is applied to
packets.
exception Exception rule is applied to packets.
exception http-redirect
Classifier Groups and Policy Rules Overview on page 31
Chapter 4: Creating Classifier Groups and Policy Rules
Defining Policy Rules for Forwarding
37
Advertisement
Table of Contents
