Route Map Configuration Mode; Router Configuration Mode - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x System Basics Configuration Guide

Route Map Configuration Mode

In this mode, you can create and modify route maps.
From Global Configuration mode, type the route-map command and the appropriate
routeMapNumber, and press Enter.
host1(config)#route-map unis889
host1(config-route-map)#?

Router Configuration Mode

In this mode, you can configure a routing protocol using router commands.
From Global Configuration mode, type the router command and the appropriate
router attributes, and press Enter.
host1(config)#router bgp 2378
host1(config-router)#?
address-family
aggregate-address
auto-summary
bgp
default
default-fields
default-information
disable-dynamic-redistribute
distance
do
exit
help
ip
limits
log
macro
maximum-paths
neighbor
network
no
overload
116
Accessing Command Modes
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
match Identify this entry as requiring an attribute match
match-set Identify this entry to match and set attributes
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
set Configure this entry to set attributes
sleep Make the Command Interface pause for a specified duration
Enter address family configuration mode
Create an aggregate entry in BGP routing table
Automatic summarization of redistributed routes
to their natural network masks
Configure BGP
Set a command to its default(s)
Set default fields for show commands
Configure the distribution of default routing
information
disable dynamic importing of routing
information with the latest policy
Configure administrative distances for routes
Run an exec mode command (alias command run)
Exit from the current command mode
Describe the interactive help system
Configure the type of route to be contributed
by this BGP address family
Configure limits on internal BGP tables
Configure logging settings
Run a CLI macro
Configure the maximum number of equal-cost paths
Specify neighbor properties
Identify a network for BGP to announce
Negate a command or set its defaults
Configure BGP behaviour when reaching overload
state (no more resources available)