If-Match Extcommunity; If-Match Interface - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches

6.1.20 if-match extcommunity

Syntax
if-match extcommunity ext-comm-list-number&<1-16>
undo if-match extcommunity [ ext-comm-list-number&<1-16> ]
View
Routing policy view
Parameters
ext-comm-list-number: Extended community list number, in the range of 1 to 199.
&<1-16>: Indicates the argument before it can be entered up to 16 times.
Description
Use the if-match extcommunity command to specify extended community list(s) for
matching against the extended community attribute of routing information.
Use the undo if-match extcommunity command to remove the match criterion.
The match criterion is not configured by default.
Examples
# Create a routing policy named policy1 with node 10, matching mode as permit. Match
the extended community attribute of routes against extended community lists 100 and
150.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match extcommunity 100 150

6.1.21 if-match interface

Syntax
if-match interface { interface-type interface-number }&<1-16>
undo if-match interface [ interface-type interface-number ]&<1-16>
View
Routing policy view
Parameters
interface-type: Interface type
interface-number: Interface number
&<1-16>: Indicates the argument before it can be entered up to 16 times.
Chapter 6 Routing Policy Configuration Commands
6-16