Default - H3C MSR 810 Command Reference Manual

undo bandwidth

Default

The expected bandwidth (in kbps) equals the interface baudrate divided by 1000.
Views
VSI interface view
Predefined user roles
network-admin
Parameters
bandwidth-value
Usage guidelines
The expected bandwidth is an informational parameter used only by higher-layer protocols for
calculation. You cannot adjust the actual bandwidth of an interface by using this command.
Examples
# Set the expected bandwidth to 10000 kbps for VSI-interface 100.
<Sysname> system-view
[Sysname] interface vsi-interface 100
[Sysname-Vsi-interface100] bandwidth 10000
default
Use
default
Syntax
default
Views
VSI interface view
Predefined user roles
network-admin
Usage guidelines
CAUTION:
The
default
the impact of this command when you use it on a live network.
This command might fail to restore the default settings for some commands for reasons such as
command dependencies and system restrictions.
To resolve this problem:
1. Use the
2. Use their
3. If the restoration attempt still fails, follow the error message instructions to resolve the problem.
Examples
# Restore the default settings for VSI-interface 100.
<Sysname> system-view
[Sysname] interface vsi-interface 100
: Specifies the expected bandwidth, in the range of 1 to 400000000 kbps.
to restore the default settings for a VSI interface.
command might interrupt ongoing network services. Make sure you are fully aware of
command in interface view to identify these commands.
display this
forms or follow the command reference to restore their default settings.
undo
36