ADTRAN AOS Version R10.1.0 Command Reference Manual page 2861

Command Reference Guide
address-family
Use the address-family command to configure the Internet Protocol version 4 (IPv4) or Internet Protocol
version 6 (IPv6) Border Gateway Protocol (BGP) address family (AF) for the default or nondefault VPN
routing and forwarding (VRF) instances on the AOS device. This command also enters the AF's
configuration mode. Use the no version of this command to remove the AF from the BGP configuration.
Variations of this command include:
address-family ipv4
address-family ipv6
Syntax Description
ipv4
ipv6
Default Values
By default, the AF is not configured on either the default or nondefault VRF instance.
Command History
Release 18.3
Release R10.1.0
Functional Notes
The address-family command can be used to create an AF on either the default or nondefault VRF
instance. If the AF is to be created on a nondefault VRF instance, the VRF instance must first be created
using the command vrf <name> route-distinguisher on page
VRF instance, you can configure the BGP settings for the VRF instance using the command
on page 2877 from the router's BGP Configuration mode. For example, to configure the IPv4 BGP
characteristics for the nondefault VRF instance RED1, enter the following commands:
(config)#vrf RED1 route-distinguisher ip 192.17.250.24:33
(config)#router bgp 100
(config-bgp)#vrf RED1
(config-bgp-vrf)#
For more information about VRF and Multi-VRF BGP configuration, refer to the configuration guides
Configuring IPv4 Multi-VRF in AOS (article number 2156) and Configuring BGP in AOS for Releases
18.03.00/R10.1.0 or Later (article number 3524) available online at https://supportforums.adtran.com.
60000CRG0-35E
Creates an IPv4 BGP AF.
Creates an IPv6 BGP AF.
Command was introduced.
Command was expanded to include IPv6 functionality.
Copyright © 2012 ADTRAN, Inc.
1460. Once you have created the nondefault
BGP Command Set
vrf <name>
2861