Table of Contents
Advertisement
Command Reference Guide
ipv6 nd ra interval
Use the ipv6 nd ra interval command to specify the interval between transmission of Internet Protocol
version 6 (IPv6) router advertisement (RA) messages. This command is only effectual when the interface
is in router mode. Use the no form of this command to return to the default value. Variations of this
command include:
ipv6 nd ra interval <max time>
ipv6 nd ra interval <max time> <min time>
ipv6 nd ra interval msec <max time>
ipv6 nd ra interval msec <max time> <min time>
Syntax Description
<max time>
<min time>
msec
Default Values
By default, the interval is set in seconds and has a maximum interval time of 200 seconds and a minimum
interval time of 75 percent of the maximum seconds value, but not less than 3 seconds.
Command History
Release 18.1
Functional Notes
If this router is used as a default router, the interval between RA messages should not be set to a larger
value than the RA lifetime set by the command
default value of 1800 seconds.
Usage Examples
The following example specifies that the maximum interval in seconds between RA message
transmissions is 300:
(config)#interface vlan 1
(config-vlan 1)#ipv6 nd ra interval 300
60000CRG0-35E
Specifies the maximum interval between RA message transmission. Time
can be specified in seconds or milliseconds. Range is 4 to 1800 seconds
and 70 to 1800000 ms.
Optional. Specifies the minimum interval between RA message
transmission. Time can be specified in seconds or milliseconds. Range is
3 seconds to 75 percent of the configured maximum time value in seconds,
or 30 ms to 75 percent of the configured maximum time value in ms.
Optional. Specifies that the time values are in milliseconds.
Command was introduced.
ipv6 nd ra lifetime <value> on page
Copyright © 2012 ADTRAN, Inc.
VLAN Interface Command Set
2776, which has a
2775
Advertisement
Table of Contents
