Command Reference Guide
Enter the IPv4 BGP Neighbor Configuration mode from the BGP Configuration mode as follows (for the
default VRF instance):
>enable
#configure terminal
(config)#router bgp 1
(config-bgp)#neighbor 192.22.73.101
(config-bgp-neighbor)#
Enter the IPv6 BGP Neighbor Configuration mode from the BGP Configuration mode as follows (for the
default VRF instance):
>enable
#configure terminal
(config)#router bgp 1
(config-bgp)#neighbor 2001:DB8:1::1
(config-bgp-neighbor)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
description <text> on page 70
do on page 71
exit on page 73
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
ebgp-multihop <value> on page 2881
hold-timer <value> on page 2883
local-as <value> on page 2885
password <password> on page 2887
remote-as <value> on page 2889
transport connection-mode on page 2891
update-source <interface> on page 2893
60000CRG0-35E
Copyright © 2012 ADTRAN, Inc.
BGP Neighbor Command Set
2880